Equipment

This routine allows you to enable the factory Trailer Tow Wiring Harness: 4-PIN or 7-PIN.

This procedure allows you to add/remove the Power Liftgate (sales code JRC) to the current vehicle configuration. It is required to install/remove the appropriate components included in the Power Liftgate kit.

This procedure allows you to add/remove the Headlamp Washer (sales code JHS) to the current vehicle configuration. It is required to install/remove the appropriate components and connect wire harness to the Headlamp Washer Motor Output. Typical wire harness layout: BCM Connector D Pin 6 -> Power Distribution Center PDC Relay + Fuse F17 -> PDC Output Connector C1 Pin 7. It is recommended to check the wiring diagrams in the vehicle service documentation.

Allows you to activate or deactivate the Sway Bar module (Jeep Wrangler JK only)

Allows you to activate or deactivate the factory rear back-up camera.

Allows to enable the HFM UConnect feature on your vehicle's just like it would be from the factory. Vehicle specific UConnect Handsfree Kit is required.

This Routine allows you to activate or deactivate the Front Fog Lamps.

Allows you to activate or deactivate the Remote Steering Wheel Switches.

Allows you to enable or disable the Trailer Brake Controller.

Allows you to activate or deactivate the EVIC Display for the appropriate cluster module.