Keys & Security

This function allows you to locate any ignition keys that have been learned by the Passive Entry Module (PEM). Number of keys located in the different areas of the vehicle will be checked. Ignition Switch should be in the Run Position.

This function will verify if the antenna coil located inside the RF-HUB is functional. Ignition Switch should be in the Run Position.

This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN functionality along with the RKE functions. Ignition Switch should be in the Run Position.

This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition Switch should be in the Lock State.

This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition Switch should be in the Lock State. Refer to the Factory Service Manual for the details.

This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition Switch should be in the Lock State. RFH Flash Part Number should be 68252600AA or greater for this routine. Refer to the Factory Service Manual for the details.

This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN functionality along with the RKE functions. Ignition Switch should be in the Run Position.

This routine will allow you to convert a currently programmed Administrator Key to a KeySense Key and vice versa. Please note that there must be at least one Administrator Key programmed at all times. The 5-digits vehicle Immo PIN code will be needed.

This function allows you to read Immo PIN Code from the Siemens WCM module.

This function should be run when a new PEM (Passive Entry Module) is installed or new FOBIK keys are programmed or replaced. It will program the vehicle PIN, transfer the secret key data, and transfer the FOBIK IDs to the PEM. Ignition Switch should be in the Run Position.

This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition Switch should be in the Lock State.

This function should be used to erase all ignition Keys/FOBIKs currently programmed to the vehicle. It is not possible to erase only one selected Key/FOBIK. Ignition Switch should be in the RUN State.

This function erases all ignition keys currently programmed to this vehicle. Ignition Switch should be in the Run Position.

This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN functionality along with the RKE functions. Ignition Switch should be in the Run Position.

This function allows you to verify if the LF Antennas are connected and function properly. Ignition Switch should be in the RUN Position.

This function allows you to verify proper connection between PEM and Door Handles. Ignition Switch should be in the RUN Position.

This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition Switch should be in the Lock State.