Equipment
Headlamp Washer (JHS)
This procedure allows you to add/remove the Headlamp Washer (sales code JHS) to the current vehicle configuration. It is required to install/remove the appropriate components and connect wire harness to the Headlamp Washer Motor Output.
Typical wire harness layout: BCM Connector D Pin 6 -> Power Distribution Center PDC Relay + Fuse F17 -> PDC Output Connector C1 Pin 7.
It is recommended to check the wiring diagrams in the vehicle service documentation.
Typical wire harness layout: BCM Connector D Pin 6 -> Power Distribution Center PDC Relay + Fuse F17 -> PDC Output Connector C1 Pin 7.
It is recommended to check the wiring diagrams in the vehicle service documentation.
Run this on your car with OBDify
Check if your car is supported — free — then run guided procedures from your phone. iPhone or Android.
