Lighting
Rear Stop / Turn Signal settings - Ram Trucks
Allows you to customize of the Rear Stop / Turn Lights working mode to adapt the Ram Trucks rear lights to European requirements.
For european market mode: usually you can enable BCM Rear Turn Lamps Output and add wire harnesses between BCM Connector E Pin 3 / F Pin 42 and rear turn lamps. In addition, disabling the rear lamp diagnostic lines can help to fix the turn signal hyper flash. Alternatively, if you hardwire Rear to the Front Turn Signals (A pin 13, D pin 14) set all parameters as Disabled.
There are no factory european settings for Ram Trucks. These vehicles were never factory designed for the European market.
For european market mode: usually you can enable BCM Rear Turn Lamps Output and add wire harnesses between BCM Connector E Pin 3 / F Pin 42 and rear turn lamps. In addition, disabling the rear lamp diagnostic lines can help to fix the turn signal hyper flash. Alternatively, if you hardwire Rear to the Front Turn Signals (A pin 13, D pin 14) set all parameters as Disabled.
There are no factory european settings for Ram Trucks. These vehicles were never factory designed for the European market.
Run this on your car with OBDify
Check if your car is supported — free — then run guided procedures from your phone. iPhone or Android.
