Immobilizer
22 procedures in this system.
-
Door Handle Verification Test
This function allows you to verify proper connection between PEM and Door Handles. Ignition Switch should be in the RUN Position.
-
ELV Replaced
This function should be run when the ELV and WCM/WIN have been replaced. NOTE: Both components must always be replaced together.…
-
Erase All Ignition Keys
This function erases all ignition keys currently programmed to this vehicle. Ignition Switch should be in the Run Position.
-
Erase All Ignition Keys/FOBIKs
This function should be used to erase all ignition Keys/FOBIKs currently programmed to the vehicle. It is not possible to erase…
-
KeySense Key Edit
This routine will allow you to convert a currently programmed Administrator Key to a KeySense Key and vice versa. Please note…
-
Lock Ignition FOBIK - (FOBIK)
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
PCM Replaced
Use this function when the PCM has been replaced. PIN code will be needed.
-
PEM Replace
This function should be run when a new PEM (Passive Entry Module) is installed or new FOBIK keys are programmed or replaced. It…
-
Program Ignition FOBIK
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
Program Ignition FOBIK - Highline (Keyless Go)
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
Program Ignition FOBIK - Lowline (FOBIK)
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
Program Ignition FOBIKs
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
Program Ignition Keys or Key FOBs
This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN…
-
Program Ignition Keys or Key FOBs - SKIM
This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN…
-
Program Ignition Keys or Key FOBs - SKIM Omron
This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN…
-
Read PIN Code
This function allows you to read Immo PIN Code from the Siemens WCM module.
-
Reset WIN Configuration
This function reset WIN vehicle configuration. Use this function ONLY when the gateway vehicle configuration has changed after…
-
WCM LIN bus configuration
This procedure will show the WCM LIN bus configuration and allows you to edit the settings. Absolutely do not use this procedure…
-
WCM PIN Code Reset/Change
This routine will allows you to change or reset the WCM PIN Code. Absolutely do not to use this procedure unnecessarily! This…
-
WCM VIN Erase
This routine will erase the WCM VIN. Absolutely do not to use this procedure unnecessarily! This routine can be useful, eg.…
-
WCM/WIN Replace
This routine should be used when the WCM/WIN module has been replaced. This procedure will (1) learn VIN and PIN code if not…
-
Write PCM VIN
This function allows you to write PCM Current VIN Number.
