Keys & Security
17 procedures in this system.
-
Door Handle Verification Test
This function allows you to verify proper connection between PEM and Door Handles. Ignition Switch should be in the RUN Position.
-
Erase All Ignition Keys
This function erases all ignition keys currently programmed to this vehicle. Ignition Switch should be in the Run Position.
-
Erase All Ignition Keys/FOBIKs
This function should be used to erase all ignition Keys/FOBIKs currently programmed to the vehicle. It is not possible to erase…
-
Immobilizer Antenna Test
This function will verify if the antenna coil located inside the RF-HUB is functional. Ignition Switch should be in the Run…
-
KeySense Key Edit
This routine will allow you to convert a currently programmed Administrator Key to a KeySense Key and vice versa. Please note…
-
LF Antenna Verification Test
This function allows you to verify if the LF Antennas are connected and function properly. Ignition Switch should be in the RUN…
-
Locate Learned Keys
This function allows you to locate any ignition keys that have been learned by the Passive Entry Module (PEM). Number of keys…
-
Lock Ignition FOBIK - (FOBIK)
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
PEM Replace
This function should be run when a new PEM (Passive Entry Module) is installed or new FOBIK keys are programmed or replaced. It…
-
Program Ignition FOBIK
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
Program Ignition FOBIK - Highline (Keyless Go)
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
Program Ignition FOBIK - Lowline (FOBIK)
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
Program Ignition FOBIKs
This function should be used when an additional Key/FOBIK need to be added or when the RFH module has been replaced. Ignition…
-
Program Ignition Keys or Key FOBs
This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN…
-
Program Ignition Keys or Key FOBs - SKIM
This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN…
-
Program Ignition Keys or Key FOBs - SKIM Omron
This function is to be used when programming a new ignition key or re-programming an existing. It will program the WIN…
-
Read PIN Code
This function allows you to read Immo PIN Code from the Siemens WCM module.
