Initialize EGS

This function should be used only when the EGS TCM has been replaced or needs to be re-initialized. It will write the current vehicle configuration, programmed tire size, axle ratio etc.
CAUTION! This function in case of programming failure may in extreme case disable the vehicle in case of outdated software version in the NAG1 gear controller or if a non-recommended OBD2 interface is used. To be sure, before using contact us.
NOTE: This routine may have set DTCs in other ECUs. Please cycle the key OFF for a minumum of 30 seconds and clear any DTCs that might have been set during the procedure.
The usage of this routine is at your own risk!