ABS & Braking
ABS Initialization
ABS Initialization may be required after replacing the ABS module or changing some vehicle settings.
Vehicle must be stationary, on level ground with the wheels straight and the brake pedal must be released.
Engine must NOT be running, and Ignition must be in RUN position when continue.
Vehicle must be stationary, on level ground with the wheels straight and the brake pedal must be released.
Engine must NOT be running, and Ignition must be in RUN position when continue.
Systems: ABS & Braking
Run this on your car with OBDify
Check if your car is supported — free — then run guided procedures from your phone. iPhone or Android.
More ABS & Braking procedures
- ABS Bleed Brakes
- ABS Initialization - Part 1: Static ECU Initialization
- ABS Initialization - Part 2: G-Sensor Calibration
- ABS Initialization - Part 3: Drive Test
- ABS Initialization - Part 4: Clearing Rolls Information
- Brake and TMC Pressure Sensors Calibration