ABS & Braking
Brake and TMC Pressure Sensors Calibration
This Routine is used to Brake Pressure Sensor and Tandem Master Cylinder (TMC) Pressure Calibration.
DO NOT press brake pedal when performing this procedure.
This procedure may also be required after Proxi Alignment has been performed or when error codes C0021-93 or C0046-54 have been read.
Refer to the Factory Service Manual for the details.
DO NOT press brake pedal when performing this procedure.
This procedure may also be required after Proxi Alignment has been performed or when error codes C0021-93 or C0046-54 have been read.
Refer to the Factory Service Manual for the details.
Systems: ABS & Braking
Run this on your car with OBDify
Check if your car is supported — free — then run guided procedures from your phone. iPhone or Android.
